How to calculate Mean, Median and Mode in python

- 
#CALCULATE MEAN

import numpy as np
speed= [99,86,87,88,111,86,103,87,94,78,77,85,86]
x = np.mean(speed)
print(x)

#CALCULATE MEDIAN
import numpy as np
speed= [99,86,87,88,111,86,103,87,94,78,77,85,86]
x = np.median(speed)
print(x)

#CALCULATE MODE
from scipy import stats
speed= [99,86,87,88,111,86,103,87,94,78,77,85,86]
x = stats.mode(speed)
print(x)

Comments

Post a Comment

Popular posts from this blog

ESP32 Error: A fatal error occurred: Timed out waiting for packet content.

-
Image
This article provides a complete solution for the most common Fatal error that usually occurs while uploading the code to ESP32. In this article I have interfaced DOIT ESP32 devkit V1 module with MG995 servo motor on GPIO = 18. You can use any module of your choice. Servo Motor Connections: Most analog servo motors like the MG995 use a 3-wire color-coded cable for interfacing. Although the color-coding is not an official standard many manufacturers use the same colored wires: 1)Orange – The PWM servo control input. This is a logic-level signal, and most servo motors can accept 3.3-volt logic as well as 5-volt logic. Some models, especially 270-degree rotation servos, use a White wire for this connection. 2)Red – The servo motor power supply input. Generally 3.3-5 volts DC, but be sure to check first. 3)Brown – The ground connection. On some servo motors, this is a Black wire ESP32 PWM Most micro controllers can be used to generate PWM signals and the ESP32 is certainly no ex...
Read more

Detecting Obstacles and Warnings with ultrasonic sensor

-
Image
Components Required: 1x Arduino 1x Ultrasonic sensor 1x Buzzer 1x Jumper wires Application: https://www.arduino.cc/ Code: int trigPin = 6; int echoPin = 5; int buzzPin = 2; void setup() {   Serial.begin(9600);     pinMode(buzzPin, OUTPUT);    pinMode(trigPin, OUTPUT);   pinMode(echoPin, INPUT);   // put your setup code here, to run once: } void loop() {   long duration, distance;   digitalWrite(trigPin,HIGH);   delayMicroseconds(1000);   digitalWrite(trigPin, LOW);   duration=pulseIn(echoPin, HIGH);   distance =(duration/2)/29.1;   Serial.print(distance);   Serial.println("CM");   delay(10);    if((distance<=10))    {     digitalWrite(buzzPin, HIGH); }    else if(distance>10)  {      digitalWrite(buzzPin, LOW);    } } Your project is all set...!!! Visit my YouTube channel once and see more interesting projects. https://www.youtu...
Read more