8-Bit adder circuit diagram

-

 8-Bit Adder circuit on Proteus







Comments

Post a Comment

Popular posts from this blog

ESP32 Error: A fatal error occurred: Timed out waiting for packet content.

-
Image
This article provides a complete solution for the most common Fatal error that usually occurs while uploading the code to ESP32. In this article I have interfaced DOIT ESP32 devkit V1 module with MG995 servo motor on GPIO = 18. You can use any module of your choice. Servo Motor Connections: Most analog servo motors like the MG995 use a 3-wire color-coded cable for interfacing. Although the color-coding is not an official standard many manufacturers use the same colored wires: 1)Orange – The PWM servo control input. This is a logic-level signal, and most servo motors can accept 3.3-volt logic as well as 5-volt logic. Some models, especially 270-degree rotation servos, use a White wire for this connection. 2)Red – The servo motor power supply input. Generally 3.3-5 volts DC, but be sure to check first. 3)Brown – The ground connection. On some servo motors, this is a Black wire ESP32 PWM Most micro controllers can be used to generate PWM signals and the ESP32 is certainly no ex...
Read more

Sending and Receiving IR sensor data through NRF24L01

-
Image
NRF24L01 is known as a multiceiver as it can transmit and receive data at the same time over a distance of 100 meters. It is an inexpensive yet reliable two way RF module. It is a cheap module which could be bought only for 2 bucks online  on various sites  making it one of the most inexpensive data communication options that you can get. Hardware rundown: Radio Frequency : 2.4GHz  worldwide ISM(Industrial Scientific and Medical) frequency band and uses GFSK modulation  for data transmission. Power Consumption: 1.9-3.6V SPI Interface: It communicates over a 4-pin Serial Peripheral Interface with a maximum data rate of 10Mbps with 125 selectable channels with an SPI configuration. Modulation Format: GFSK Maximum Operating Current: 13.5mA Max Air data rate: 2Mb/s Infrared sensors IR   sensor also known as Infrared sensor   is an electronic device that computes and detects   infrared   radiation in its surrounding environment. Active   infrared ...
Read more

Detecting Obstacles and Warnings with ultrasonic sensor

-
Image
Components Required: 1x Arduino 1x Ultrasonic sensor 1x Buzzer 1x Jumper wires Application: https://www.arduino.cc/ Code: int trigPin = 6; int echoPin = 5; int buzzPin = 2; void setup() {   Serial.begin(9600);     pinMode(buzzPin, OUTPUT);    pinMode(trigPin, OUTPUT);   pinMode(echoPin, INPUT);   // put your setup code here, to run once: } void loop() {   long duration, distance;   digitalWrite(trigPin,HIGH);   delayMicroseconds(1000);   digitalWrite(trigPin, LOW);   duration=pulseIn(echoPin, HIGH);   distance =(duration/2)/29.1;   Serial.print(distance);   Serial.println("CM");   delay(10);    if((distance<=10))    {     digitalWrite(buzzPin, HIGH); }    else if(distance>10)  {      digitalWrite(buzzPin, LOW);    } } Your project is all set...!!! Visit my YouTube channel once and see more interesting projects. https://www.youtu...
Read more